Door bottoms
The flap meets the floor and stops the draft that sneaks under the door.
Pickup currently not available
Processing takes 5–15 business days. Tracking provided.
Stop cold drafts at doors and windows with a clear strip you cut and stick.
Orders are processed in 5–15 business days. Transit times vary by destination. See our Shipping Policy for estimates. Every order is tracked. We email you a tracking link when your parcel leaves.
You have 30 days to return an item. Email support@easedwell.com first and we'll tell you how.
If it arrives damaged, faulty or wrong, email us a photo with your order number. We'll resend it or refund you.
Clear self-adhesive draft seal
A see-through strip you cut to length and stick along the bottom or edge of a door, window or glass screen. Its clear flap bridges the gap, so cold air, dust and drips stay out while the door opens as normal.
The problem
Most doors and windows close against a frame with a little gap left over. You feel it as a cold draft at your ankles, a whistle on windy nights or a line of grit along the floor. The heating works harder to fill a room that keeps leaking at the edges.
Windows and glass screens leak the same way, along the sash or the bottom edge. The fix does not need a contractor or a caulk gun, just something that bends with the door and stays out of sight.
How it works
Each strip has two zones along its length. That simple split is what lets it close a gap without jamming the door.
1 The adhesive band sticks to the door face. 2 The clear flap bends down to the floor and stops the cold draft (blue arrow) at the gap.
A narrow strip of pre-applied adhesive under a peel-off film. It grips clean glass, wood, plastic and metal.
The rest of the width stays free. It rests against the frame, floor or tub edge and closes the gap.
The flap flexes as the door or window moves, so it seals when shut and gets out of the way when open.
Up close: one edge carries the adhesive under its backing film; the rest is a free flap you can bend double. Household scissors cut it cleanly.

Fitting
Wipe the edge where the strip will sit. Dust and grease are what stop tape from holding.
Measure the run, mark it and cut with household scissors. You can trim it narrower too.
Peel back the first few inches of film from the adhesive band. Line the strip up with the edge so the flap just touches the floor or frame.
Keep peeling and pressing firmly along the whole length without stretching the strip. Close the door to check the flap sits flat.
Good to know: fit it on a dry day, not in freezing or wet conditions. Room temperature and a firm press along the whole length give the adhesive its best hold.
Where it goes
Cut a piece for each spot that lets the cold in. One 5 m roll covers about five standard door bottoms.
The flap meets the floor and stops the draft that sneaks under the door.
Run it along the hinge side and the top, where the door meets the frame.
Along the track or the edge where the sash closes, so the wind stops whistling through.
Sticks to clean glass. Under a shower screen it keeps splashes in the tub.
Also handy on: patio and French doors, balcony windows, kitchen cabinets and drawers, garage doors, RV and camper doors.
More than the cold
Once the gap is bridged, the things that used to slip through it have nowhere to go. In this test, a handful of loose beans thrown at a sealed door piles up along its bottom edge instead of rolling underneath.

Clear by design
Foam tape and rubber seals are made to be seen. This strip is transparent, so it takes on the color of whatever it is stuck to: white trim, a dark oak door like this one, or a chrome shower frame.
It follows the line of the edge and keeps a low profile, so nobody notices it until they notice the draft has gone.
Sizes
Every roll is 5 m (16.4 ft) long. The wider the strip, the wider its clear flap, and the bigger the gap it can cover.
| Width | Adhesive band | Clear flap | Best for |
|---|---|---|---|
| 25 mm0.98 in | about 10 mm | about 15 mm (0.6 in) | Small gaps: interior doors, window sashes |
| 35 mm1.38 in | about 10 to 15 mm | about 20 to 25 mm (0.8 to 1 in) | Medium gaps |
| 45 mm1.77 in | about 15 mm | about 30 mm (1.2 in) | Larger gaps and uneven floors |
Band and flap widths are approximate and can vary between batches.
The one rule: pick a width whose clear flap is wider than your gap, so the flap overlaps the floor or frame instead of just reaching it.
Compared
Specifications
| Product | Self-adhesive clear seal strip for doors, windows and glass screens |
|---|---|
| Widths | 25 mm (0.98 in), 35 mm (1.38 in) or 45 mm (1.77 in) |
| Length | 5 m (16.4 ft) per roll |
| Color | Transparent |
| Backing | Pre-applied adhesive band under a peel-off film |
| Sticks to | Clean, dry glass, wood, plastic and metal |
| Use | Indoors and outdoors, water-resistant |
| Fitting | Cut with scissors, peel and press, no tools or screws |
In the box
On clean, dry surfaces it comes off most finishes cleanly. On fragile paint or wallpaper, test a small piece first.
The adhesive is meant for long-term use. Peeling it off and sticking it back down weakens the grip, so place it carefully the first time.
Wipe with a damp cloth. In the shower, rinse it with the rest of the screen. Keep unused strips away from small children and pets.
An open gap lets cold air, dust and bugs straight under the door.
The clear flap rests on the floor and closes the gap. The door still swings.
Your warmer home
Measure the gap, pick a width, cut a piece for each drafty door and window, and press it into place. Tonight the cold stays outside where it belongs.
We choose practical things that do a real job around the house, describe them honestly, and look after you if something isn't right. Questions? support@easedwell.com
This product costs less when you buy more. The savings are real and are applied automatically in your cart, with no code needed.